The first prototype was designed on the basis of GMC AFKWX (Cab Over Engine). It is is a threesome that presided over its development: Rod Stephens Jr. of the firm Sparkman & Stephens Inc. who was designer of yachts, Dennis Puleston, an English navigator who resided in the US and Frank W. Speir, a Reserve Officer at the Massachusetts Institute of Technology (MIT).<\/p> \n \n
The GMC DUKW 353 showed its capabilities during a sea trial when it managed to save seven coastguards in rough seas when their boat ran aground, proving its effectiveness.<\/p> \n \n
The final design which was put into production was upgraded by engineers of Yellow Truck & Coach Manufacturing Company of Pontiac, Michigan. It was based on the GMC CCKW (For the sake of knowledge, note that the Yellow Truck & Coach Co was founded by John D. Hertz who founded the famous car rental company in the 1950s).<\/p> \n \n
The acronym DUKW refers to project identification at General Motors Corporation: D for the design year (1941), U for Utility, K for all-wheel drive and W for dual rear axle.<\/p> \n \n
The DUKW was quickly dubbed DUCK (Duck) by the soldiers. This craft can carry up to 5,000 lb (2.3 t) or 25 equipped soldiers. Widely used in amphibious operations, including the Normandy landing, its great maneuverability made it fit to perform shuttle between the very large transport ships and the beaches or to cross the rivers and travel long distances on roads.<\/p> \n \n
Easy to produce and maintain because using the same mechanical components as the GMC CCKW 353 (banjo axles), it was manufactured from 1942 to 1945.\u00a0 21147 were produced. Although one could sum up the craft as being a classic GMC CCKW 353 with the addition of a waterproof shell, the differences due to this adaptation are still numerous. Chassis, engine, clutch, transmission, transfer case and banjo axles are those of the CCKW, although the banjo axles are adapted to receive the water tight shaft tunnel.<\/p> \n \n
Excluding the hull, propeller, rudder and anchor that are the immediate distinctive features of this \u201ctruck\u201d, a significant difference from the CCKW is the presence of a compressor to allow control of the tire pressure. This provision was first made possible by the inventiveness of Speir. The compressor finding place in the front compartment, the drive shaft extends the engine crankshaft through the radiator. Because the engine is enclosed in the shell, the cooling is provided by a flow of air sucked behind the crew seats and rejected by two large side vents, one on each side. Adjustable deflectors in these vents allowed to send some of the hot air to the bilge to prevent the two bilge pumps from freezing in winter conditions.<\/p> \n \n
Other notable features are:<\/p> \n \n
\u00a0<\/p> \n \n
Engine\u00a0: GMC 270 valve-in-head, 6 cylinders in line, 269.5 cu.in (4.4 l), 104 hp at 2\u00a0750 rpm
\n
\nTransmission\u00a0: 6\u00d76, 5 speed\/transfer 2 speed
\n
\nWinch capacity\u00a0: 10,000 lb (4.5 t)
\n
\nLength\u00a0: 3721\/8<\/sup>\u201d (9.45 m)
\n
\nWidth\u00a0: 96\u201d (2.44 m)
\n
\nHeight\u00a0: 1061\/16<\/sup>\u201d (2.70 m)
\n
\nGround clearance\u00a0: 111\/4<\/sup>\u201d (28.5 cm)
\n
\nWeight\u00a0: 14,500 lb (6,58 t)
\n
\nPayload : 5,000 lb (2.3 t)
\n
\nMaximum speed
\n
\nRoad : 50 mph (80 km\/h)
\n
\nWater : 5.4 mph (8.7 km\/h)
\n
\nRange on land : 240 miles (386 km)
\n
\nRange in water : top speed 30 miles, cruising speed 50 miles<\/p>
\n \u00a0<\/p>
\n Below are some interesting pictures of a DUKW being restored at UNIVEM.\u00a0 They show in detail the specifics of the DUKW<\/p>
\n\n\t\t\t